How to choose a street sensor to turn on the light: get that advice about virobniki

Ergonomics of the lighting control system does not only mean the nuances of manual adjustment of accessories. The best way to save electricity, as it is within the reach of a balanced control of operating modes. All the most popular systems of automated control of lamps are becoming at the link with the cim, so as not to lie in front of the vlasnik himself. Having adjusted the measure for specific parameters, you can not worry about the regulation of the working process - we change it under the control of electronics. The widest control tool of the same type is a sensor for turning on the light. A photo of the outdoor model of this outbuilding is presented below. This is a typical detector design, the design of which is endowed with the basic shells of an out-of-this-world zakhistu.

Attachment and principle of robotic sensor

Calls and fittings are made up of small plastic boxes, which contain sensitive elements. Attached to the point, where the passage of people is transmitted. For example, a thief, a maidan, a gank toshcho. When approaching the zone, the sensor fixes the proximity and gives a signal for the lancet to flicker, after which the lamp turns on automatically. Like a whole ceramic vanity, there are spotlights, likhtars, lighting, ceiling lamps and other lighting fixtures. In the fallow land, a street sensor is installed, to increase the light, you can observe a single pause before it, as if closing the lance. Tsya mozhlivіst vpravdana, yakshcho lords it is necessary to pass a few meters to the month, de bude prilad. It is not great to allow to save a small number of vats, but for a long-term victoria, we will give a great economy. The basic choice is based on the principle of work of a visceral sensitive element. Depending on the method of reaction to rux, the sensors are classified into sprat types.

Ultrasonic models

The principle of development is grounded on changes in the parameters of the ultrasonic wave, which is how it releases an attachment. The design of transmissions has a sensitive element as a vipprominuvach with a frequency range of 20-60 kHz. Wider fluctuations in the service area and in case of a shutdown with an object that is collapsing, then a return signal reception with a further activation of the hum. The variability and independence of the air temperature are available - the main advantages of such sensors in the room for turning on the light. Street exposure of ultrasonic models is visible and tim, that stench exudes low sensitivity to third-party factors. That way, when a leaf gets into a field of suffocation, it reacts without bringing lighting fixtures to a pardon. From the other side, the creatures can watch the anxiety become in the presence of ultrasound, and the evil-doer can “bypass” the sensor, collapsing smoothly.

Infrared sensors

In times of attachment, they react to the heat of viprominuvannya. For whom the optical filling with lenses and a sensitive sensor is transmitted, which fixes the infrared wave. In the fall, depending on the tightness of a particular one, I will build a quantity of lenses, it can become 20-60 pcs. From the same time, the more, the zone of the received signal was expanded. To the strong sides of such outbuildings, you can see a wide range of sight and distance - outdoor sensors for turning on the light on the basis of optical sensors can serve a radius of more than 10 m with 360-degree scanning. But at the same time, the height of the landfilling of the central zone will lead to a serious lack of sight at the sight of a great number of hibnih spratsovuvan. The classic butt is the infusion of sleepy shifts on infrared receivers. But for the creatures and the people themselves in the form of such detectors is minimal.

Microwave models

Response, like in vipadku ultrasonic attachments, as a result of changes in the parameters of the hvilovy vipromonition. As a rule, the sensors are vicorated, which provide overfrequency expansion of the intensity of 1 mW/cm2. This allows the detectors not only to scan the city's maydanchik for the subject of traffic, but also to detect people behind partitions, doors and strike with thin walls. The reaction rate should not lie under the influence of weather phenomena and temperature conditions. Who is going to pay for such advances? A micro-violet street sensor for turning on lighting equipment is expensive, but it can be more potentially risky of a negative impact on healthy people in the form of a similar viprominuvannya like this. With the method of minimization, shkod fakhivtsi is recommended for the use of butovyh needs to fill models of corn cob with small working displays.

Combined extensions

As it is obvious from the name, it is a hybrid with the improvement of a number of sensors. Zokrema, there are two types of vip production – ultrasonic and microfine. The result of the combination allowed us to use a part of the nedolіkіv, pritamannyh dermal s tsikh technologies skanuvannya okremo. So, the weak point of the operational process was lost in the appearance of a high performance of low performance and low accuracy. As a rule, tse gnuchkіshі and in terms of installation of sensors to the floor to turn on the light. The street way of stosuvannya is completely true to itself and from the point of view of physical protection, and with wide possibilities of connection to different types of light possession.

Main characteristics for selection

The first working parameters are already guessed indications of the range of spratsovuvannya and cooling. The minimum radius should be 4-6 m. The maximum distance can reach 20-25 m - the optimal characteristics of outdoor sensors in the room for turning on the light in the open area in front of the cottage. Well, I’ll look back to the kuta, those vins are picked up for the improvement of specific minds zastosuvannya. Chim bigger place, tim wider maє buti kut - from 60 to 360 degrees.

Okrema respect is attached to zahisnym yakos prilad, shards of wines of vicorists are to be found on a bright wind with the usual threats of weather phenomena. As a minimum, the protection class is responsible for the approval of the IP54 brand. This designation points to a high step saw and water insulation. And best of all, you should focus on the outdoor sensor for turning on the light IP65, which also has a better shell for the type of straight-lined physical injection. The hull is protected by impact-resistant coatings with a complete set of water-, pilot- and frost-resistant prosharks.

Notes about RANEX models.

The company promotes standard, but at the same time, and functional versions of sensors for any street lighting system. Koristuvach sensors in the quality of the brand signify their design advantages in terms of appearance, reliability and durability, as well as ergonomics of control and flexibility in fittings. For example, there is a lot to praise the outdoor sensor for turning on the light RANEX for the ability to monitor the temperature change in the range of air from -20 to 60 ° C, without losing the accuracy of fixing the object. For the variant, it is also a wholesome option. for 600-800 rubles. you can find a suitable accessory for a deputy householder.

Notes about Brennenstuhl models.

The extensions of the lines of the greater world are oriented towards the commercial victoriousness, but the private rulers often swell them through the temple of superiority. Also, among the positive aspects of the operation of regulatory electronics, the firms consider a small part of the pardons, the possibility of implementing an autonomous energy supply and the distance of delivery. For example, a street roc sensor for turning on the light at 20 meters with infrared building detectors to serve the entire area with maximum visibility. If necessary, the working model can be reconfigured, specifying the cooling spectrum and radius. Behind the words of the koristuvachiv, you allow the robot to work with an attachment that is unfamiliar to creatures.